version: "2026.1.0" language: "en"

Pass

The Pass block is used to end an automation case run in the passed state. This block is essential to explicitly indicate that a flow has completed successfully.
Important : Without a Pass or Done block in a flow, Leapwork will automatically mark the end result as a Fail. Always include one of these blocks to signal successful completion.

Need an example? See the Introduction lesson.

Fully expanded, the Pass block shows the following properties:

Note: The screenshot on this page uses the Elegance Design , introduced in 2025.3. If you are using an earlier version, your layout may look different.

Quick-start

1. Drag Pass onto the canvas.
2. Connect the block to the end of your flow to finalize the case in the Passed state.
3. (Optional) Define a Pass message and add fields to include dynamic values.
4. Run the flow when it's ready.

Building block parameters

Parameters

1. Pass message: Define a message to be logged when the case passes. This can contain tokens for field values.
2. Text fields : Allow the use of external values in the pass message. Insert tokens by right-clicking in the Pass message field and selecting Insert token.
3. Add field : Add custom fields to be referenced as tokens in the Pass message.

Resources